CWI TOOLS

1 .
Measures undercut Crown height and
checks porosity .
ACCURATE
1.Undercut depth or crown height scale can
be read to 1/3 inch.
.!orosity co"parison o# 1/$ inch and 1/1%
inch. &inear gauge in 1/1% inch incre"ents.
EA'( T) U'E*
!ointer is easy to set and a locking screw
holds it in position #or later re#erence.
+igures and incre"ents are etched into
sur#ace. They are easy to read and will not
rub o,.
+ast*
All #our re-uired "easure"ents are "ade
with a
Part No. Description
WG—5 Gauge with 1/64" Tolerance
WG-5- Gauge with WTP! Gauge
an" #loc$
WG-5-% Gauge !et
WG-5--% Gauge !et with WTP!
Gauge an" #loc$
WG-5& &etric Gauge with 1/64"
2 .
'()'*! +ND),'+T
D)PT(
'()'*! -&.+NT ./ P.,.!0T1
P),
20N)-, 0N'(
'()'*! P.,.!0T1
'.&P-,0!.N
'()'*! ',.WN
()0G(T
تاوطخلا
1.To Deter3ine the !i4e o5 a 6llet wel"7
!lace the gauge against the toe o# the .llet weld
and slide pointer out until it touches structure as
shown. Read /'i0e
o# the +illet 1eld/ on the #ace o# gauge as indicated
by arrow.
8.To 'hec$ the Pe3issi9le Tolerance o5
'on:e;it<
A#ter the si0e o# a con2e3 weld has been
deter"ined4 place the gauge against the structure
and slide pointer until it
touches #ace o# .llet weld as shown. The "a3i"u"
con2e3ity should not be greater than indicated by
/Ma3i"u"
Con2e3ity 'cale/ as indicated by arrow #or the si0e
o# .llet being checked.
=.To 'hec$ the Per3issi9le Tolerance o5
'onca:it< an" +n"er6ll
!lace gauge against structure and slide pointer out
until it touches the #ace o# the .llet weld as shown.
5# the pointer does not touch as shown4 the .llet
re-uires additional weld "etal.
4.To 'hec$ the Per3issi9le Tolerance o5
,ein5orce3ent
!lace gauge so that rein#orce"ent will co"e
between legs o# gauge and slide pointer out until it
touches the #ace o# weld as shown.