F 220 L1000 0 (ENTER)
-A CS: 100 (ENTER)
xxxx:0100 MOV AX,301 (ENTER)
xxxx:0103 MOV BX,200 (ENTER)
xxxx:0106 MOV CX,1 (ENTER)
xxxx:0109 MOV DX,80 (ENTER) <---"80" for hd1, "81" for hd2 >
xxxx:010C INT 13 (ENTER)
xxxx:010E INT 20 (ENTER)
xxxx:0110 (ENTER) <-------BLANK LINE "VERY IMPORTANT" >
-G (ENTER)
Program terminated normally
- (CTRL)-(ALT)-(DEL) to reboot system
NOTICE:
Performing the following will remove all data from your hard disk drive.
NOTE:
Type the bolded text only (the debug prompt is a dash). You will receive an erro
r if you type anything other than the bold text. The non-bolded text represents
the system response that will appear after typing each command and press the key
.
debug
-F 200 L1000 0
-A CS:100
xxxx:0100 MOV AX,301
xxxx:0103 MOV BX,200
xxxx:0106 MOV CX,1
xxxx:0109 MOV DX,80
NOTE:
Type 80 for the Main hard drive - HD 0, or type 81 for the Second hard drive - H
D 1.
xxxx:010C INT 13
xxxx:010E INT 20
xxxx:0110 (Leave this line blank and press the key)
-G
The message, Program terminated normally, appears. Turn off the computer by pres
sing the power button.
On the next startup the hard drive must be partitioned and formatted.