Firewall
Content
FireWall:
Portfarwarding/Destination NAT: Step1: Add a new Portfarwarding/Destination NAT rule() Step2:Select the red interface IP(Fig: Nat/firewall/Port_farwarding/nating4) Step3: Select the service type and select the on which port(Fig: Nat/firewall/Port_farwarding/nating 5 & 6) Step4:Select which ip (green interface ip) and port(Fig:Nat/firewall/Port_farwarding/nating 7 & 8) Step5: Select NAT(Nat/firewall/Port_farwarding/nating9) Step6:Check the enabled and log(Nat/firewall/Port_farwarding/nating10) Step7: Type the Remark for remember the purpose of the forward rule Step8: create the rule and apply. Then the Nating is enabled. Source NAT: This rule is used for The network is behind the firewall(Intranet). Step1: Firewall-->Source NAT-->add new source NAT RULE--> add the local network IP/Subnetmask-->Select the Interface--> select the source--> select the port-->type the port no. in destination port (which is user defined)-->Select the NAT--> Selct the auto-->create rule-->Apply. System Access: This is used for Remote access of firewall. Fig: Nat/firewall/System Access.(service is tcp and port is 10443(Endian firewall access on 10443 address only.))
Proxy: Http:
Enable the http Proxy--> select the Not Transparent (If you transparent mode is enabled, all requests for the destination port 80 will be forwarded to the Proxy Server without the need of any special configuration changes to your clients) Access Policy: The access policy is applied to every client that is going through the proxy, regardless of its authentication. Access policy rules are time-based access policies based.
Portfarwarding/Destination NAT: Step1: Add a new Portfarwarding/Destination NAT rule() Step2:Select the red interface IP(Fig: Nat/firewall/Port_farwarding/nating4) Step3: Select the service type and select the on which port(Fig: Nat/firewall/Port_farwarding/nating 5 & 6) Step4:Select which ip (green interface ip) and port(Fig:Nat/firewall/Port_farwarding/nating 7 & 8) Step5: Select NAT(Nat/firewall/Port_farwarding/nating9) Step6:Check the enabled and log(Nat/firewall/Port_farwarding/nating10) Step7: Type the Remark for remember the purpose of the forward rule Step8: create the rule and apply. Then the Nating is enabled. Source NAT: This rule is used for The network is behind the firewall(Intranet). Step1: Firewall-->Source NAT-->add new source NAT RULE--> add the local network IP/Subnetmask-->Select the Interface--> select the source--> select the port-->type the port no. in destination port (which is user defined)-->Select the NAT--> Selct the auto-->create rule-->Apply. System Access: This is used for Remote access of firewall. Fig: Nat/firewall/System Access.(service is tcp and port is 10443(Endian firewall access on 10443 address only.))
Proxy: Http:
Enable the http Proxy--> select the Not Transparent (If you transparent mode is enabled, all requests for the destination port 80 will be forwarded to the Proxy Server without the need of any special configuration changes to your clients) Access Policy: The access policy is applied to every client that is going through the proxy, regardless of its authentication. Access policy rules are time-based access policies based.
